APPLYING POWER Without any peb's inserted turn the Main Power Switch into ON. the card rack, By looking into the card rack, you will see four LEDs adjacent to CN2 on the motherboard (See Figure 6). One for each type of power required by the DX-1. (+5V=RED, -5V=GREEN, +12V=YELLOW, +13V=AMBER). Note that all four LEDS are lit. Should any fail to light there may power supply. be a mis-connection or a fault in the CAUTION DO NOT UNDER ANY CIRCUMSTANCE INSERT PCB'S INTO THE CARD CAGE UNTIL ALL LEDS ARF LIT! DO NOT INSERT OR REMOVE PCB'S WHILE POWER IS APPLIED TO CARD RACK! TO DO SO MAY CAUSE IRREPARABLE DAMAGE TO THE PCB'S AND WILL VOID THE WARRANTY.
After determining that all four LEDs are lit, turn the Main Power Switch OFF. Insert the pebs into the card rack. Determine that all four LEDs are still lit, if so turn off the main power switch and proceed with further interconnection.