CONTROL PANEL OVERLAY INSTRUCTIONS: The generic Tata East Control Panel Overlay supplied, has been specifically designed to retain the player controls within the two sets of lines printed on the overlay. It is shipped with a very strong adhe- sive applied to one side which is protected with an easy-release paper backing. Since the overlay is oversize, carefully position it over the con- trol panel before removing the protective backing to determine exactly how it will be installed. Remove the backing and apply the overlay to the panel as it was positioned above. Smooth the overlay from the center of the panel towards the edges being sure to remove air bubbles as you proceed.
The excess overlay material at the top and bottom of the control panel should be wrapped around the edges to prevent players from peeling the material off. All holes may be cut and other excess overlay material may be trimmed using an Exacto Knife or razor blade. Carefully apply the appropriate pushbutton decals and install new pushbuttons according to the schedule below. 1PLAYER, 2PLAYER SHOOT 1 (Fire, Action) SHOOT 2 (only when reqd) THE Yellow Red Blue MONITOR PLEX OR GLASS: Many been manufactured with graphics screen the back the removed of side or a removing of new clear the screen plex. These plex games graphics installed. printed material have printed to must.
be One method is to soak a rag in lacquer thinner and wipe the plex clean. It may take repeated applications of the thinner to completely remove all traces of the graphics. An oversized black Cardboard Underlay has been supplied to be placed under the monitor plex. Using masking tape, of the underlay trim the excess temporarily align the viewing with the monitor screen. cardboard as required. hole Mark and