Specifications and Regulatory Information Modem Reference Information 186 Corporate Evaluator’s Guide Command Function (3Com) F0 Turn online echo on F1 Turn online echo off H0 Hang up (go on-hook) H1 Pick up (go off-hook) I0 Display the 4-digit product code I1 Display the checksum I2 Display the RAM test results I3 Display the firmware version I4 Display the current modem settings I5 Display user profiles I7 Display the product configuration I8 Display blacklist screen I10 Display VXD configuration screen I11 Display V.34 link screen L0 Set modem speaker volume off L1 Set modem speaker volume on (low) L2 Set modem speaker volume on (medium) L3 Set modem speaker volume on (high) M0 The modem’s speaker is always off M1 The modem’s speaker is on until a connection is made M2 The modem’s speaker is always on M3 The modem’s speaker is off during dialing, and on after dialing until the connection is made O0 Return to online mode O1 Return to online mode and retrain (automatically return to the highest speed) S$ Display the list of S-register settings Sr=n Set S-Register “r” to “n” Sr?
Display the value of S-Register “r” V0 Display result codes in numeric form V1 Display result codes in verbose form (words) X0 Report basic call progress result codes, i.e., OK, CONNECT, RING, NO CARRIER, (also, for busy, if enabled, and dial tone not detected), NO ANSWER and ERROR X1 Report basic call progress result codes and the connect rates—OK, CONNECT, RING, NO CARRIER (also, for busy, if enabled, and dial tone not detected), NO ANSWER, CONNECT XXXX and ERROR X2 Report basic call progress result codes and the connect rates i.e., OK, CONNECT, RING, NO CARRIER (also, for busy, if enabled), NO DIAL TONE, NO ANSWER, CONNECT XXXX and ERROR X3 Report basic call progress result codes and connection rate i.e., OK, CONNECT, RING, NO CARRIER, NO ANSWER, CONNECT XXXX, BUSY and ERROR X4 Report all call progress result codes and connection rate i.e., OK, CONNECT, RING, NO CARRIER, NO ANSWER, CONNECT XXXX, BUSY, NO DIAL TONE and ERROR Y0 On the next reset, use &W0 settings Y1 On the next reset, use &W1 settings Y2 On the next reset use, &F0 settings Y3 On the next reset, use &F1 settings Y4 On the next reset, use &F2 settings Z0 Reset the modem according to the settings of ATY Z1 Reset the modem and use &W0 settings Z2 Reset the modem and use &W1 settings Z3 Reset the modem using &F0 settings and load factory default profile 1 Z4 Reset the modem using &F1 settings and load factory default profile 0