HP — Modem Reference (3Com)

Specifications and Regulatory Information Modem Reference Information Corporate Evaluator’s Guide 187 Command Function (3Com) Z5 Reset the modem using &F2 settings and load factory default profile 2 $ Display the list of AT commands &$ Display the list of ampersand commands &A0 Disable data compression result codes &A1 Enable data compression result codes &A2 Enable modulation result codes &A3 Enable data compression result codes and add V.42bis and MNP 5 protocol indicators &B0 Use a floating DTE speed &B1 Use a fixed DTE speed &B2 Use a fixed DTE speed when using data compression &C0 Carrier detect is always on &C1 Carrier detect is controlled by the modem.

&D0 Ignore DTR &D1 Use online command mode &D2 DTE controls DTR &D3 DTE controls DTR and reset &F0 Set the factory profile that uses hardware (RTS/CTS) flow control (this is the active profile when the modem is shipped) &F1 Set the factory profile that uses hardware (RTS/CTS) flow control &F2 Set the factory profile that uses software (XON/XOFF) flow control &G0 No guard tone &G1 Use 550 Hz guard tone &G2 Use 1800 Hz guard tone &H0 Flow control for transmitted data - Disable flow control &H1 Flow control for transmitted data - Enable hardware flow control (RTS/CTS) &H2 Flow control for transmitted data - Enable software (XON/XOFF) &H3 Flow control for transmitted data - Enable both software and hardware flow control &I0 Flow control for received data - Disable flow control &I1 Flow control for received data - send XON/XOFF signals to modems on both ends &I2 Flow control for received data - send XON/XOFF signals to your modem only &I3 HP Eng/Ack in Host mode &I4 HP Eng/Ack in Terminal Mode &I5 Flow control for received data - If error correction is used, send XON/XOFF signals to your modem only; if data compression is not used, look for incoming XON/XOFF &K0 Disable data compression &K1 Enable data compression (V.42bis, MNP 5, NONE) &K2 Enable data compression (forces V.42bis) &K3 Use selective data compression &M0 Disable error correction in 1200 bps and faster transfers &M4 Allow V.42 or MNP error correction in 1200 bps and faster transfers &M5 Allow either V.42 or MNP error correction in 1200 bps and faster transfers &Nn Set link speed (bps):

0=Highest speed, 1=300, 2=1200, 3=2400, 4=4800, 5=7200, 6=9600, 7=12000, 8=14400, 9=16800, 10=19200, 11=21600, 12=24000, 13=26400, 14=28800, 15=31200, 16=33600, 17=28000, 18=29333, 19=30666, 20=32000, 21=33333, 22=34666, 23=36000, 24=37333, 25=38666, 26=40000, 27=41333, 28=42666, 29=44000, 30=45333, 31=46666, 32=48000, 33=49333, 34=50666, 35=52000, 36=53333, 37=54666, 38=56000, 39=57333 &R1 Ignore RTS &R2 Receive to DTE/RTS high &S0 Data Set Ready (DSR) is always on