HP — Modem Reference (Ambit)

Specifications and Regulatory Information Modem Reference Information Selected Result Codes (3Com) Modem Reference (Ambit) In the following AT command table, default settings are shown in bold.

All listed AT commands except A/ must be preceded by “AT.” AT Commands (Ambit) 190 Corporate Evaluator’s Guide Code Meaning 0 OK 1 CONNECT 2 RING 3 NO CARRIER 4 ERROR 5 CONNECT 1200 6 NO DIAL TONE 7 BUSY 8 NO ANSWER Command Function (Ambit) A/ Re-execute command (not preceded by AT) A Go off-hook and attempt to answer a call B0 Select V.22 connect @1200 bps B1 Select Bell 212A connect @1200 bps C1 Return OK message Dn Dial modifier E0 Turn off command echo E1 Turn on command echo H0 Initiate a hang-up sequence H1 If on-hook, go off-hook and enter command mode I0 Report product code I1 Report pre-computed checksum I2 Report “OK” if the calculated checksum equals the prestored checksum or if the prestored checksum value is FFh I3 Report firmware revision, model, and interface type I4 Report response programmed by OEM I5 Report the country code parameter I6 Report modem data pump model and code revision I7 Report the DAA code L0 Set low speaker volume L1 Set low speaker volume L2 Set medium speaker volume L3 Set high speaker volume M0 Turn speaker off M1 Turn speaker on during handshaking and turn speaker off while receiving carrier M2 Turn speaker on during handshaking and while receiving carrier