Tire pressure monitoring system 4.3-15 Wireless air leak learning (learning without tools) 1- Protection Place protective pads at following locations: · Front fender; · Front bumper; · Driver’s seat; · Carpet (on driver's side); · Steering wheel; · Parking brake lever; · Shift lever. 2- Learning steps: CAUTION • After the tire rotation, replace the tire pressure monitoring sensor, and do tire learning after the tire pressure monitoring control unit has been replaced. When there is no tool, wireless air leak learning can be performed.
• With the ignition switch or start-stop button turned to "ON" position, the tire pressure information will be displayed on the instrument cluster display by pressing the instrument cluster control button. • Press the hold the instrument cluster control button“OK”on the steering wheel for 3 s to enter the tire system learning mode,in this case, the “Tire Pressure Learning Begins” will be displayed on the interface. • If the left front wheel (1) is deflated with air leakage exceeding 8.25 kPa within 30 s, and ID learning of left front wheel is completed by the TPMD control unit, the instrument cluster will display "Left Front Wheel Learning Completed" and buzzer will beep once.
• Follow the above steps to complete the learning of the right front wheel (2), the right rear wheel (3), and the left rear wheel (4). The instrument cluster will display “Right Front Wheel Learning Completed”, “Right Rear Wheel Learning Completed” and "Left Rear Wheel Learning Completed”.