Tire pressure monitoring system 4.3-14 • Press and hold the locking clip of the connector, and disconnect the connector (1) of the tire pressure monitoring control unit wire harness . • Remove the tire pressure monitoring control unit (2). 4- Refitting • Connect the tire pressure monitoring control unit connector (1) in place. • Refit the TPMS in place and preinstall its fixing bolts (1). • Tighten the fixing bolts (1) of the tire pressure monitoring control unit with a 10mm socket wrench. • Refit the trunk left protective plate.
(Refer to the section "Removal and Refitting of Trunk Interiors" in the chapter "Interiors and Exteriors") CAUTION • After the installation is completed, clear the DTC and perform the TPMS matching learning.