Chapter 3 Creating and Editing Screens 3.8.2.3 Set Value Button 3-102 Revision May, 2010 Property Description of Set Value Buttons After pressing this button on the screen, a system built-in numeric keypad (TEN-KEY) will show up and the user can use it to input the setting value directly. When ENTER key is pressed, HMI will send the input setting value to PLC corresponding register. The maximum and minimum input setting values are all user-defined. The user can also specify the trigger mode to trigger the designated PLC address before or after writing the setting value. Write Address The address can be internal memory or the controller address.
(Please refer to Table 3-8-2 Property Description of General Buttons.) Text Text Size Font Text Color The user can set the text, text size, font and text color provided by Windows® to determine the text display on the element (Please refer to Table 3-8-2 Property Description of General Buttons.) Bank (Picture Bank) Picture Name (Please refer to Table 3-8-2 Property Description of General Buttons.) Transparent Effect Transparent Color (Please refer to Table 3-8-2 Property Description of General Buttons.) Foreground Color Style (Please refer to Table 3-8-2 Property Description of General Buttons.) Trigger Trigger Type The user can use this setting to trigger the designated controller address to be ON before or after writing the setting value.
Please note that this function can only trigger the controller address to be ON. If the controller address needs to be triggered again, the user should set the address to be OFF manually. Range Setting Data Length: There are 16bits Word and 32bits Double Word two options. Minimum/Maximum: The user can set the minimum and maximum of input setting value to determine the range of input setting value.