Chapter 3 Creating and Editing Screens Revision May, 2010 3-115 Property Description of System Function Buttons Trigger Trigger Type The user can use this setting to trigger the designated controller address to be ON before or after writing the setting value. Please note that this function can only trigger the controller address to be ON. If the controller address needs to be triggered again, the user should set the address to be OFF manually. Report Device This option is provided in Report List button only. When the user selects a Report List button, the user can set this option in the property table. The Report Device window is shown as the figure above.
The Report Device can be USB flash drive (USB disk), Printer and SD card. USB flash drive Output the history records and alarm data to USB disk. Printer HMI will check if Print Typesetting function is set or not first. If Print Typesetting function is set already, the screen data will be output to the printer directly. If HMI detects the Print Typesetting function is not set yet, the Hard Copy function will be enabled. SD Output the history records and alarm data to SD card. User Security Level Use this option to set the user priority for pressing this element. Only the priority that is equal to or higher than the current setting can use this element.
InterLock Address InterLock Level When InterLock Address is set to be ON or OFF (this is determined by the property of “InterLock Level”), this button can be enabled.