Chapter 3 Creating and Editing Screens 3.8.5.2 Pipe(3) Revision May, 2010 3-127 Property Description of Pipe (1) / Pipe (2) Elements Low Region Color High Region Color This option is available and displayed in the property table only when the “Ranges” option in the Detail Setup dialog box is selected. If the user sets the low limit value is 20 and the color of low limit region is in green, and then set the high limit value is 80 and the color of high limit region is in red, the pipe element will be shown as the figures below:
When the value is 20 When the value is 50 When the value is 80 X Used to set X coordinate Y Used to set Y coordinate Width Used to set the element width Height Used to set the element height Property Description of Pipe (3) Element It is used to connect to water pipe element. Pipe (3) element is shown as the figure below: Pipe Gauge: Use this option to set the pipe gauge. The selectable range is from 1 ~ 5. The setting value 1 represents at least 13 pixels and the setting value 2 represents at least 26 pixels and vise versa. X Used to set X coordinate Y Used to set Y coordinate