Mitsubishi — 3.8.11.1 Trend Graph

Chapter 3 Creating and Editing Screens 3-170 Revision May, 2010 Property Description of Trend Graph Elements Setting Sample Number Max. Sample Number Please note that when the sample number is a constant, the Max. Sample Number option is disabled. When Sample Number is a variable value: When the sample number is set to the address (register), the sample number is a variable value. The user can change the value of the address to modify the sample number at the same time. When the sample number is a variable value, the Max. Sample Number option must be set. If the read value is more than the set Max. Sample Number, the system will take the set Max.

Sample Number as the actual maximum sample number. Data Format Word 1. BCD 2. Signed BCD 3. Signed Decimal 4. Unsigned Decimal 5. Hex Read Address The address can be internal memory or the controller address. (Please refer to Table 3.2.2 Property Description of General Buttons.) The trend graph will continuously read numbers of addresses from the read address set by the user, convert the read data into trend graph and display on HMI screen. The numbers of the addresses is determined by the setting of “Sample Number”. Sample Flag It is used to set trigger and clear flag. When sample flag is triggered, it will start to read data and draw the graph.

This sample flag is located within the control block. Please refer to section 3.4 in Chapter 3 for the settings of the control block. Minimum Maximum It is used to set the minimum and maximum value of the display data, i.e. the minimum and maximum value of Y-axis. If the read value is more the maximum or less than the minimum, the system will display the minimum and maximum value still.