Chapter 3 Creating and Editing Screens Revision May, 2010 3-227 General tab in Configuration option Project Name Enter the name of the file for the project. HMI Type Select DOP-B series HMI type for different functions and requirements Non-volatile data location The backup memory data (non-volatile data) can be saved in HMI and USB disk. The user can select one of them from the Location drop-down list. However, USB disk selection is available in some HMI types. Therefore, it depends on which HMI the user select. The setting of non-volatile data location is shown as the figure below.
After pressing Setting button, Retained Area dialog box will pop up and the user can set the storage location of alarm, recipe and history data in this dialog. Password Used to set the highest priority password. There are 8 levels for the password. Meanwhile, this password is also the protection password for the file (project). Please note that the password format is in hexadecimal (0 ~ F). Starting Level Used to set start-up priority. The highest level is 7 and the lowest level is 0.。 Insufficient password level reminder When this check box is checked, if the priority for the element that is not equal to or higher than the current setting, will display to remind the user.
Buzzer ON When this check box is checked, the function of Buzzer is enabled.