Chapter 3 Creating and Editing Screens END (End the Macro) Equation Statemenets1 END Statements2 Explanation End command is used to end the macro program and all statements after the END command will not be executed. If this command is in a main macro then the program will go to the first line again and begin execution, if this command is in a sub-macro then the sub-macro will end and the program will return to the previous program. Remark It executes the Statemenets1 and then ends the macro executing. It does not execute the Statements2. Statement is the combination of a section of macro commands and also can be If there is END command in sub-macro, the program ends here.
If the user within the nested loop. wants to return to the previous macro program, please user RET command. Example After the operation, the result is $1 = 11, not $1 = 12 as the END command has ended the macro program. 3.14.3.7 Bit Setting There are various kinds of commands for Bit setting. For more details, please refer to the following sections. BITON (Set Specific Bit to be ON) Equation BITON Var1 Explanation This command sets Var1 bit to be ON. Revision May, 2010 3-351