Mitsubishi — 3.14.3.8 Communication

Chapter 3 Creating and Editing Screens 3.14.3.8 Communication There are various kinds of commands for communication. For more details, please refer to the following sections.  INITCOM (Initial setup COM port) Equation Var1 = INITCOM (Var2) Explanation This command uses initial setup COM port to start communication and set communication protocol. After the user sets each COM port, this command starts communication and stores the result in Var1. Remark  Var1: Response value after communication 1: Completed normally 0: Failed  For the settings of Var2, please refer to the following table of Var2 Settings in INITCOM (Communication Protocol). 3-354 Revision May, 2010