US Army Materiel Command AMCP 706-250 — Engineering Design Handbook: Guns Series — Guns-General

Downloaded from https://www.everyspec.com bersome. To move a heavy English cannon, even over good ground, required 23 horses. was an efficient piece, though subject to easy fouling that made it dangerous. Under the Swedish warrior, Gustavus Adolphus, artillery began to take its true position on the battlefield in the 17th century. It was he who combined the powder charge and projectile into a single cartridge to do away with the old method of ladling powder into the gun and so increased the rapidity of fire. Recognizing the need for mobile weapons, he made use of pieces which could be moved by only 2 horses and served by 3 men.

In the past, 1 cannon for each thousand infantry- men had been standard. Gustavus brought the ratio to' 6 cannon per thousand men. The American Civil War began with smooth-bore muzzle loaders and ended with rifled, muzzle load- ers. When they wore out or were captured, smooth- bore weapons were replaced with rifled pieces. One specific weapon converted from a smooth-bore to a rifled bore is noted in the Rodman gun. De- veloped by Capt. T. J. Rodman (United States Army Ordnance) in the mid-1800's, this smooth- bore weapon was cast around a water-cooled core. Its inner walls thus solidified first and were com- pressed by the contraction of the outer metal as it cooled more slowly.

By this process, it had much greater strength to resist explosion of the charge. The Rodman smooth-bore cannon, cast in 8-, 10-, 15-, and 20-inch calibers, was the best cast-iron ordnance of its time. During the Civil War and after, a number of the 10-inch Rodmans were con- verted into 8-inch rifles by enlarging the bore and inserting a grooved steel tube. About 1750 Frederick II, King of Prussia, suc- ceeded in developing artillery that was light enough and mobile enough to accompany the army and be readily maneuvered on the battlefield. 1-4 Rifling Adopted The principle of stabilization of an elongated projectile by rotation has been known a long time.

However, difficulties in manufacture of the guns and ammunition retarded the development. In small arms there were some rifled muskets in use in the 18th century, utilizing projectiles which expanded at the base to fit into the rifling grooves of the muzzle loaders. The development could not be successfully applied to the manufacture of can- non and their ammunition until breech-loading was developed. The first successful breech-loading guns were made less than a century ago. There were some breech-loading cannon made over 400 years ago, but judged by our standards, they were far from satisfactory and were not the forerunners of mod- ern breech-loading guns.

1-5 Breech Loading Developed The need for breech loading was obvious; to enable firing and reloading without exposing the gunners to the enemy. Solution of the breech loading problem depended primarily on finding a mechanism that would seal the propellant gases within the chamber. This was accomplished by using soft metal (brass) cartridge cases for the smaller guns and more complex expanding asbestos and metal seals for the larger ones. The first gun that may be called modern and in the sense that it had all the features now in use was the '' French 75." This 75-mm gun, model of 1897, had modern sights, firing mechanism, recoil mechanism, and used cased ammunition.

It was the backbone of the artillery of the allied armies in World War I (1914-18). Early cannon were not made very accurately, and their accuracy of fire was correspondingly low. These weapons could not be made better than the tools which produced them, and good machinery capable of boring cannon was first made about 1750. Rifling had already been applied to small arms, but machinery of the necessary "accuracy to make cannon in this fashion was not available until about a century later. In 1816, Major Cavelli in Italy and Baron Wahrendorfl* in Germany independently produced rifled iron breech-loading cannon.

The Cavelli gun had two spiral grooves which fitted the %-inch projecting lugs of a long projectile. About the same time, an. enterprising British industrialist, Joseph Whitworth, developed the helical hexagonal- bore weapon. This weapon was one of many used during the American Civil War (1861-1865). It 1-6 Early United States Developments 1-6.1 Fixed Artillery Design characteristics of United States artillery have followed generally those of other nations.