US Army Materiel Command AMCP 706-250 — Engineering Design Handbook: Guns Series — Guns-General

Downloaded from https://www.everyspec.com drical bore classification is considered to include both smooth bores and rifled bores. At present, all U. 8. Army standard guns using bore-fitting pro- jectiles are of the cylindrical-bore type. 3-4.2 Tapered (Squeeze) and Choke Bores These terms designate guns in which the bores are tapered in the whole or some portion of their length. The tapered portion may be intermediate between two cylindrical sections of unequal diame- ter. Such bores may be smooth or rifled, or part rifled and part smooth. 3-4.2.1 Tapered (Squeeze) Bore Figurt, 3-7.

JWUd Bore {Muzzk) This term is used to denote a bore incorporating a taper designed to reduce the diameter of a bore- fitting projectile as the latter passes through from breech to muzzle. This form of bore has made a favorable showing in some aspects of performance in experimental high velocity guns. For a given diameter of projectile as expelled from the muzzle, a greater area of projectile is acted upon by the propellant pressure through the earlier part of travel through the bore.

guns, mortars and certain signal-projecting devices, have been used in a number of experimental high velocity guns for projectiles incorporating fins for stabilization in flight This type of bore, used in the great majority of recent cannon and small arms, is characterized by grooves cut in the bore surface, each groove follow- ing a helical path about the axis of the bore, for the purpose of imparting spin to the projectile about its longitudinal axis for stabilization in flight. The helical path of the grooves may be either right- hand or left-hand, and the twist may be uniform or increasing as it approaches the muzzle.

Current practice generally employs right-hand twist, which produces a clockwise rotation of the projectile as viewed-from the rear (see Figure 3-7). 3-4.3.2 Rifled Bore 3-4.2.2 Choke Bore The term is commonly applied to shotguns in which the bore is cylindrical except that, in a short portion near the muzzle, the diameter is slightly reduced by taper (choked) to lessen the lateral spread of the group of pellets after they have left the bore. Commercially, the degree of choke is measured by the percentage of pellets of a stand- ard load striking within a 30-inch diameter circle at a range of 40 yards, and denoted as follows:

3-5 Classification by Degree of Propellant Confine- ment This means of classification according to degree of propellant confinement, or degree of breech closure, is used to distinguish recoilless (open- breech closure) guns from the more conventional (closed breech) guns. Full choke 65% to 75% Improved modified 55% to 65% Modified (% choke)"45% to 55% Improved cylinder 35% to 45% 3-4.3 Classification by Surface of Bore 3-5.1 Open-breech Closures (Recoilless) Categories under this classification are (a) smooth bore and (b) rifled bore. The latter cate- gory includes the majority of military guns (see also par. 4-3.3). The open type of breech closure is employed on recoilless weapons.

In these weapons a controlled rearward discharge of propellant gases is employed to give the gun a forward impulse opposing the rearward recoil impulse incurred in discharge of the projectile, and so to virtually eliminate trans- mission of recoil forces to the gun mount. A typical recoilless rifle (see Figures 2-7 and 3-16) uses fixed ammunition with a perforated cartridge case 3-4.3.1 Smooth Bore This term denotes a bore that is without grooves, lands, or other contour intended to produce or control rotation of the projectile. Smooth bores, replaced for decades by rifled bores, except in shot-