US Army Materiel Command AMCP 706-250 — Engineering Design Handbook: Guns Series — Guns-General

Downloaded from https://www.everyspec.com . A closure in which the block is pivoted on pins at the Milfs of the barrel, forward from the breech face, and is swung upward and forward to expose the chamber opening. (e) Rising Block (d) Falling Block A closure in which the block is pivoted rearward from the breech face and is swung downward to open the breech. (e) Standing Breech, Hinged Frame This arrangement, used on some commercial de- signs of revolvers and shotguns and in military pyrotechnic pistols, presents a breechblock face formed as a fixed part of the gun frame, to which the barrel is hinged on a transverse pivot forward of and below the chamber.

Opening is effected by manual release of a securing latch or bar, and swinging the rear end of the barrel upward. A percussion firing pin is carried in the breechblock, and the frame houses the hammer, trigger and remaining parts of the firing mechanism. Typi- cally, the swinging of the barrel to open automati- cally actuates an extractor to partially withdraw the cartridge case(s) from the chamber(s). Figur* 3-16. Typical Recoillea Rifle Breech, Breechblock Locking Threads Partly Engaged on rotation of the cylinder each chamber is succes- sively aligned between the breechblock face (with firing pin) and the barrel.

The frame houses a spring-driven hammer and suitable mechanism for rotating the cylinder and locking it in successive positions to fire the cartridge in each chamber, all actuated by pull and release of the trigger. The pivot on which the cylinder rotates is hinge- mounted on the frame, and breech opening it effected by swinging the cylinder sideward and downward parallel to the breechblock face, to ex- pose the breech ends of the chambers.

Except for close positioning of the parts, no antileak provision is incorporated between the rear end of the barrel and the forward end of the aligned chamber, and the resulting loss of a fraction of the propellant bases at the unsealed junction necessitates use of relatively low power cartridges to avoid severe ero- sion of metal at the junction and escape of gases and unconsumed particles of propellant at exces- sively high temperature. Figur« 3-15.

Typical Revolver, in Section, Cartridges Chambered in Cylinder (f) Standing Breech, Solid Frame In this construction (see Figure 3-15), used in commercial revolvers and formerly in military re- volvers, the breechblock face is formed as a fixed part of the gun frame, and the barrel is rigidly mounted ahead of the breechblock face, with suffi- cient intervening space to receive the cylinder.

The latter contains six chambers, equally spaced about the longitudinal axis, which is positioned below and parallel to the bore of the barrel, so that 3-5.2.2.4 Eccentric Screw Closures (Nordenfeld) This type of closure, little used at present and applicable only to cannon of relatively small bore diameter employing fixed ammunition, incorporates 3—13