US Army Materiel Command AMCP 706-250 — Engineering Design Handbook: Guns Series — Guns-General

Downloaded from https://www.everyspec.com condition results in higher gas temperature at exit, with attendant increase in flash. The effect of the tube design on the production of smoke and flash becomes obvious from the discussion of the causes in paragraph 5-6.1 The tube and propellant charge, with some contribution by the projectile, are jointly responsible for the conditions represented by the contour of the pressure-travel curve, including the composition, condition, and state of the propellant charge material at exit from the gun muzzle.

These attributes of the discharged material, in turn, sub- stantially determine the occurrence or absence of smoke and both primary and secondary flash. Figur* 5-2. Flash Hidmr 5-6.4 Elimination of Flash and Smoke 5-6.4.1 Flash Flash may be most effectively reduced by such combination of barrel, projectile and propellant designs as will cause the combustion of the propel- lant to be completed while the projectile is still near the breech, so that subsequent expansion will suffi- ciently cool the propellant gases before exit from the muzzle.

While this is feasible in some small arms, it is unsuitable for many weapons because of the opposing demand for obtaining high projectile velocities from guns of least practical overall size and weight. Consequently, where needed, other methods of minimizing flash are used, with varying degrees of effectiveness. Figur» 5-3. Flash Suppressor attached to the muzzle of the barrel, and serves to conceal the emerging flash from sideward view, but is ineffective against observation from positions well forward of the gun. The flash suppressor comprises a muzzle attachment providing several forward-projecting prongs extending from a collar on the gun muzzle.

This device eliminates or re- duces the flash resulting from a secondary burning of the propellant gases at the muzzle. The reduc- tion is due to the cooling action on the emerging Chemical methods introduce additional material into the propellant charge. One approach adds material to evolve quantities of nitrogen or other nonexplosive or partially combustible gases to ab- sorb heat and so lower the exit temperature of the propellant gas mixture to a point below the igni- tion temperature of the combustible gases con- tained. The resulting dilution of combustible gases may further reduce the likelihood of occurrence of secondary flash.

The temperature reduction ef- fected by this method may entail some loss of energy. Another approach is the addition of cer- tain salts which have been found effective in preventing re-ignition of hydrogen and carbon monoxide in the ejected propellant gas. This method, while suppressing flash, generally produces 5-6.4.2 Smoke Means of minimising the production of visible smoke are the subject of continual investigation.

One approach is aimed at avoidance or reduction of smoke-producing compounds in the propellant; another has the objective of reducing the visible products of incomplete combustion by improving the co-ordination of design of gun and propellant, so that desired ballistic performance can be achieved with (a) propellant charge composition and combustion processes that will leave a practical minimum of smoke-producing elements or com- pounds in the discharged gases; and (b) ejection moke. Mechanical means of flash reduction include muzzle attachments designated as flash hiders or flash suppressors (Figures 5-2 and 5-3). The flash hider consists of a conical tube with its small end