Downloaded from https://www.everyspec.com of the gases, vapors and particles resulting from combustion and projectile passage in a condition as unfavorable as possible to undesired atmospheric reaction. such modifications or refinements as are deemed necessary or desirable by the ammunition designer. Test firings are then conducted to determine whether the desired performance and other charac- teristics have been attained. If the firing test results indicate the desirability of further modifi- cations in the gun or propellant charge, or both, the indicated changes are coordinated and accom- plished, and the results checked by further test firings.
The modification and test procedures are repeated until a satisfactory combination is ob- tained. 5-7 Fitting the Propellant and the Gun 5-7.1 General Considerations The interdependence of gun design and propel- lant charge design can hardly be over-emphasized. Within limits, the design of either may be adjusted to accommodate the characteristics of the other, so a number of coordinated combinations may be found to satisfy a given projectile velocity require- ment. The range of possible combinations, how- ever, does not present an area for uncoordinated choice by either gun or propellant designer.
Rather, it provides a measure of latitude for joint effort to combine, with the required velocity, other characteristics (as light weight, short barrel, fa- cility of ammunition handling, for example) to the extent found practicable and desirable in the in- tended use of the weapon. 5-7.3 Estimation of Weight and Granulation of the Charge The details of methods and procedures of de- signing a propellant charge are covered in other handbooks of the Series. The following discussion indicates only the basic elements and procedures.
The weight of propellant charge must be such as to provide the energy to (1) accelerate the pro- posed projectile to the desired muzzle velocity (translations and rotational); and (2) supply all energy losses incurred in the firing of the round, with the charge burning under confinement by the gun and advancing projectile, and the resulting gases and residue discharging to the atmosphere as the projectile leaves the muzzle. The losses in- clude the following: 5-7.2 General Procedure The initial requirements for a new design of gun usually include the desired caliber, type and weight of projectile, muzzle velocity or range of firing, and overall limitations on gun length and weight.
Since the velocity of the projectile is imparted by the pressure of the propellant while confined in the gun chamber and bore behind the accelerating projec- tile, the initial step in the design of the gun is the calculation, by the ammunition designer, of com- binations of chamber volume, bore length and propellant charge that will impart the required velocity to the projectile without exceeding tem- peratures and pressures suitable for gun design.
In view of the stated weight, dimensional or other limitations or desired characteristics, the appar- ently optimum combination is selected and the pertinent data, including the pressure-travel curve (see Figure 5-1) and recommended chamber dimen- sions, are transmitted to the gun designer. The latter then designs the gun in accordance with the data. If the gun designer desires any changes in the data to improve the mechanical design, the pro- posals are subject to agreement by the ammunition designer before adoption.
On concurrence in the tentative design, one or more guns of this design are built, and propellant charges are prepared with Energy remaining in the gases ejected from the gun; Energy expended in heating the gun and pro- jectile ; Energy expended in moving the products of combustion and unburned remainder for- ward behind the projectile; Energy expended in separating the projectile from a cartridge case (bullet pull), in en- graving of the projectile or rotating band (in rifled bores), and in overcoming friction of projectile passage through the bore; and Energy expended in effecting recoil of the gun.
As indicated in paragraph 5-7.1, the characteris- tics of the gun and propellant charge are inter- dependent in imparting the desired motion to the projectile. The interdependence of the various factors may be expressed mathematically by a se- ries of equations, but simultaneous solution of the equations become extremely complicated and la-