US Army Materiel Command AMCP 706-250 — Engineering Design Handbook: Guns Series — Guns-General

Downloaded from https://www.everyspec.com borious, unless simplified by various assumptions that have been found to be reasonably in harmony with experimental results. In the development of a new gun, the simplified equations are used in a trial-and-error procedure, with assumed quantity, composition, and granalation of propellant, and several assumed chamber volume-bore length-com- binations, to obtain an approximation of the total expansion volume necessary to effect required ve- locity of the known projectile, without exceeding a maximum pressure acceptable for gun or ammuni- tion design.

If a maximum permissible gun length is specified, a Corresponding bore length may be included in the original calculations, as such a re- striction will impose a corresponding minimum volume on the chamber. In the gun designer's interest, principal con- siderations include the following: The chamber diameter should be kept as small as possible, to reduce the size and weight of gun breech necessary to withstand the propellant pres- sure. The chamber length should not be such as to require a cartridge case or propellant bags of length unwieldy to handle, or necessitate undue length and clearances for mechanical loading or ramming devices.

In the ammunition designer's interest, considera- tions include the following: Excessive length-to-diameter ratios should be avoided to minimize ignition difficulties, handling and storage problems, and difficulties of manufac- ture of cartridge cases, if used. When trial calculations indicate that the assumed chamber and Weight of charge will produce a fair approximation of required velocity with permis- sible pressures, several more calculations are made, using the same chamber volume, but varying the weight of charge and "quickness" (burning rate/ web thickness) of the assumed propellant, to find the optimum combination for maximum velocity at the desired pressure limit.

Repeating this pro- cedure with several variations in chamber size will indicate the most desirable combination of chamber size, weight of propellant charge and propellant granulation to meet the specified requirements with the least possible incurrence of undesirable condi- tions or characteristics. Where metallic cartridge cases are used, ex- cessive taper of main cavity should be avoided to reduce problems of manufacture of cases. Main cavity diameter and taper, and transition and mouth proportions, must be suitable for effecting proper obturation on firing and subsequent elastic recover of case to permit satisfactory extraction.

Where obturation is provided by a cartridge case, the contour of the chamber, which must closely encircle the case, is principally determined by con- siderations of desirable case contour and length- to-diameter ratio. However, to avoid unnecessary gun weight, all possible consideration is given to keeping the ratio of chamber diameter to projectile diameter at a reasonably low value. Modifications for advantage in gun design must be fully coordi- nated with the case designer and incorporated only on determination that a case to suit the proposed chamber will function satisfactorily and is practical to manufacture.

The number of trial calculations necessary to approach a satisfactory final solution is reduced by the use of tables compiled from the results of numerous approximate calculations, showing rela- tions between velocity, loading density, gun dimen- sions, and pressure. 5-7.4 Correlation With Chamber Design In recoilless weapons, the chamber and closure must combine an accurately determined degree of propellant confinement with a precisely sized and proportioned nozzle outlet, in order to produce not only the required projectile velocity but effective recoil-neutralizing forces.

It is, therefore, of prime importance that the chamber and^ nozzle interior size and shape be as specified or approved by the interior ballistician. The calculations referred to in paragraph 5-7.3 enable the interior ballistician to determine the optimum chamber volume for a gun that is to satisfy a given set of requirements. The shape of the chamber to provide the required volume then becomes a matter for coordination between the gun designer and the ammunition designer, and the determination of the most satisfactory compromise where opposing preferences occur. 5—10