— AMCP 706-286 — Engineering Design Handbook (1963)

Downloaded from https://www.everyspec.com STRUCTURES consequence of the creep deformations, the When the column is an idealized I sectio - convex side of the middle of the column will in which all the material is concentrated in be under the action of a compressive stress two flanges a tiistance h apart, the effective a, considerably smaller than the compressive flexural rigiditv csn be calculated from tLe stress a2 on the concave side of the'middle of values of -. 'M -- d: ; with the Wi of the the column. When the bending moment is formula increased slightly, the stress on the concave 2EE. side inc.eases along the tangent to the curve.

(T EE (3-73) The slope of this tangent, namely tan a_, is For'other sections Equation (3.72) repre- the tangent modulus E, as discus'-od under sents a satisfactory approximation. paragraph 3-4.9, On the other band, on the The buckling load of the column is convex side the stress decreases along a line _ _ _ parallel to the initia] straight portion of the L) stress-strain curve because onily the elastic and the critical stress can be given as part of the deforinaons can be regained. The slope of the initial straight line, tan , -L (75) is Young's Modulus E.

where L is the length of the column, p, the 0'-radius of gyration of its cross section, and / Eqf is simply E2.t= (EI)a./I = 2EE,/(E + E,) a2 The value of Eef decreases as the deflection V / of the column ircreases. Thus the critical load P,, also decreasei until, zt the critical value of the deflection, it becomes equal to o - the applied load P. At that moment the column collapses. wConsequently, the critical deflection wu?/ be ca!culated from the instantaneous stress- ostrain curve of the material established at the proper temperature and after the proper time of exposure. The critical time is then simply the time necessary for'the creep de- formations to increase to the critical value.

For the calculation of the critical time, data on creep are also needed. Since all this infor- S EO mation is not yet available for the materials of construction, no closed formulas can be STR IN given for the critical time of columns. Efforts have also been made to calculate the critical tLne of initially perfect columns. The results obtained, however, can,ot be guro J.-12. Sfiess-troin Cur a Elevated logically corrtAated t 'the practical buckling Temperaturo times observed in experiment. : " (54l 454