Hi Downloaded from https://www.everyspec.com DESIGN CONSIDERATIONS 9 egions of moderate to high thermal in-uts. heat sink is quite different from the heat sink Developmenta! work in this directicn is uprotected type structure. In this latter nevertheless worthwhile bemu.L of the sir- case, the mass of the unprotected primary plicity and low cost possibilities structure was simply increased in order to A more promising and feasible insulated enlarge its heat absorption capacity. The structure is a double wall construction. The heat sink approach has received a great deal outer shell is fabricated from a heat rEsistant of attention bItcause of its simplicity.
Copper material and is relatively thin and light, appears to be a suitable cover material for The panels of the outer shell esse:atia!ly carry heat sink purposes primarily because of its only the local normal loads, and therefore excellent thermal diffusiviry. The poor high need be designed to withstand these. loads in temperature mechanical characteristics of only at the elevated temperature. The inner copper have not affected its use for this pur- wall or shell is the primary loae carrying pose. structure and may be cunventionai -n design Should the thermal input conditions be ex- and material.
The reason for this is that the ceptionally severe, the designee may still inner structure will not be sub.*ect to high utilize the heat sink appr.ah, except that thermal inputs and the temperature rise is the heat sink material is allowed to melt. kept low enough that material properties are The molten material is then ablated or car- not significantly affected. Interposed between ried away by the windstream. This approach the walls in a suitable light and effective insu- has been used successfully in several re-entry lator. Fo- relatively close sracing between bodies. One of the major problems in the the walls, air aoi.
mnzht effectively as application of this solution is the instability the insulating medium. If the outer panels of the ablation process. Any irregularity are designed in such a manner that each in- or pit in the surface may increase the heat dividual panel can expand or contract freely, transfer locally, melting material at a greater it offers the advantage o! complete absence rate and precipitating a very rapid and of thermal stresses. The cuter phnels can be wholesale ablation of the material in the en- allowed to float by attaching them to the pri- tire area.
mary structure -with thin strips or clips Sublimation cooling is another interesting which allow expansion of the panel in its own and promising approach to the aerodynanic plane. In additirn to tie advantage of com- heating problem for very high thermal inputs plete absence of thernid stresses, other fea- .n which the thermal shield material itself is tures of this design .nclude its feasibility sublimated at the surface, The sublimation from the standpoint (if developmental time, cooling solution is here classified as an insu- heat protection for in.ternal equipment, and lated structure inasmuch as there is a "ori- freedom from panel flutter.
mary structure which is being protected by Some ol the most interesting insulated the outer cover of material which is sublimat- structure solutions co the aerodynamic heat- ing In common with the nonmelting and ing problem have been proposed for missiles melting heat sink discussed in the preceding of long range re-entering the atmosphere at paragraphs, the sublimation cooling tech- high speeds. One of these solutions is the nique is basically one in which a thermal non-melting heat sink. In this application, shield protects a primary load-carrying the primary or load-carrying structure is structure.
Materials which show promise as covered with an engineering material in outer covers, are poor thermal conductors, sufficient quantity that it can absoib the and it appears that there is no necessity to thermal input without melting. Insulation is interpose insulation between the primary interposed be':eewmn the outer heat-absorbing structure and the outer cover. material and the inner lcad-carrying struc- The principal beneficial effects of sublima- ture in orde. to keep the lcad-carrying struc- tion cooling are in the reduction of the heat ture relatively cool. It is te be noted that this transfer coefficient due to introduction of 61