US Army Materiel Command AMCP 706-341 — Engineering Design Handbook — Carriages and Mounts Series: Cradles

Downloaded from https://www.everyspec.com ) (Figure 6a) or the elevating arc (Figure 6b). t.'. If one is used, each end of the shaft is supported I1 by the structure (Figure 7). 22. For any given angle of elevation, the -- uilibrator force is the one required to pro- Iduce the moment whichbancstewih I moment of the tipping parts. Although EOUILIBRATOR actual equilibrator forces do not always equal S1HAT the theoretically required ones, differences are (a) EQUILIBRATOR ATTACHMENT ON CRADLE STRUCTURE Hence, for design purposes, the theoretical LSTRUTRE value will be used to simplify the load analysis. ACRADLE small enough that the structure is not affected.

From Figures 8 or 9 the equilibrator force is EQ@UILI BRATOR"-' EQW.SRATOR F4- (8) SHAF WinL cos (0 + ~)+ WXr, COS (0 + 0'2) where W, = weight of recoiling parts ELEVATIPG ARC W, = weir it of cradle. (b EQUILIBRATOR ATTACHMENT ON ELEVATING ARC It is apparent-that, before the preliminary design of the cradle is completed, the equilibra- Figure 6; Equilibrator Attachments, Cantilever Type tor geometry, at least a preliminary one, must be determined in order to compute its force XV = 0 (7a) (see Reference 3). 2;H = 0 (7b) IM = 0 (7c) Assume that the axis of the bore is hori- 3. Elevating Arc In Figure 8, 42 is negative. zontal and take the moments at a convenient 23.

The attachment of the elevating arc to point such as the intersection of f2 and R 2 . the cradle should be through a well-fitting, rigid joint because the meshing of gear teeth is involved. Improper meshing of the gears 2. Equilibrator Attachment will prove detrimental in one or all of three 21. Each equilibrator, whether one or two to ways; poor load distribution may overstress the weapon, pivots on a shaft attached to the the teeth, excessive wear may occur, and gear cradle. If two are used, the shafts are usually efficiency may decrease, thus requiring an in- cantilevered from each side of the structure creased torque at the handwheel.

The attach- SSLI DE --- I ATTACHMENT--- 0 0 CRADLE , = ) : BRACKET ' EQUILIBRATOR SHAFT EQUILIBRATOR Figure 7. Equilibrator Attachment, Simple Beam Type qi~4 7