Downloaded from https://www.everyspec.com 7), mass of projectile from the key to the center of the assumed tri- N, = twist of rifling, calibers per turn angular distributed load on the projected P, = propellant gas pressure diameter. For either type cradle, the loads R,= radius of bore induced by the rifling torque are eventually a angular acceleration of projectile transmitted to the top carriage by the trun- 0, = helix angle of the rifling nion. A= rR, (9b) F 0 = Ab!' 0 (9c) B. SLIDING SURFACES OF U-TYPE CRADLE 1. Load Analysis From the general expression, F, = m,a1 F. 26. There are two types of force on the a = (9d) slides:
the normal forces and the frictional 7rf forces derived from the normal forces. The tan 0, (9e) normal forces are obtained as reactions to the rifling torque, to the couple created by the re- al = a tan 0, (9f) coil forces and the inertia of the recoiling parts, Substituting the appropriate terms of Equa- and to the weight of the recoiling parts. Thus, tions 9b, 9c, 9d, and 9e into Equation 9f and the shorter the distances between the forces collecting terms, we have parallel to the bore axis and the closer the 72R2P center of gravity is to the midspan of the a, =mN (9g) slides, the smaller will be the forces on the slides.
Actually, in single recoil systems, the a 7xlRbP 0 (9h) weight contributes little to the maximum .. a = , = m forces; therefore, the center of gravity may The valu6, k 2 = 0.6Rb is generally abcepted fall outside the slides without deleterious ef- - as an approximate value. Then fects. However, in double recoil systems, the 1, = mlk = 0.6m,,R, (9i) inertia force due to secondary recoil may pro- duce appreciable loads on the slides, and it be- Equation 9 is obtained by substituting the comes desirable not to have the center of terms of Equations 9h and 9i into Equation 9a. gravity overhang the sliding surfaces. From Figures Ila and llb, the load on the 27.
When calculating the loads on rails and trunnions due to rifling torque is guides, the distribution of bearing pressure T, should be considered. If the two mating sliding F d, (10) surfaces are continuous, a triangular load and, correspondingly, the load on the rails distribution is assumed. Triangular load dis- (Figure !ha) or on the key (Figure lbl is tribution implies zero clearance and linear com- pliance of rails and guides. The assumption of T, triangular load distribution is subject to d, change for unusual constructions. If the Note that the maximum torque occurs when sliding surfaces are discontinuous, a trapezoidal the propellant gas pressure is maximum.
distribution is assumed or, if th e pads are For the U-type cradle, the torque is trans- spaced sufficiently far apart, uniform load dis- mitted directly to the guides through the rails tribution is assumed. Figure 12 illustrates or the sleigh in the form of vertical forces hay- these effects. The diagrams represent the re- ing a moment arm equal to the distance from actions to the couple, M,., of the recoiling their lines of action to the bore axis (Figure parts. The reactions R, and R2 are calculated lla). For the 0-type cradle, the tube is by assuming that they are concentrated at the keyed to the cylindrical portion of the cradle.
center of the area that represents the dis- The torque is transmitted through the key and tributed load. After the reactions to the the contacting surface between tube and couple are found, those resulting from the cradle (Figure llb). The moment arm extends rifling torque and the normal component of the 0 811 2M,-012 (8040A) 0 - 67 - 2