US Army Materiel Command AMCP 706-341 — Engineering Design Handbook — Carriages and Mounts Series: Cradles

Downloaded from https://www.everyspec.com R. = Rh (17b) R, = Ro (17c) bR = cRo (17d) 0 Substitute the value of Ro of Equation 17 U into Equation 17a and solve for Rs- Rh A T Sin.R= R%, substitute the expressions in CRADLE any Equationzi 17 and 17e for Ro and R, in Equa------- tion 17d and qolve for b b - c (17f) This is the gusset length required to sub- stantiate the assumption of 1,he triangular load distribution. If Ro represents the area of a triangle, (1 LONITUDINAL GUSSETS IN CNORML DIECTOR then Figure 20.

Gusset Reinforced Trunnion Housings 2Ro w = C )maxmumunitloadonthegusset (18) savings in weight as the cradle wall is less able and the maximum direct tensile or compressive to sustain the induced radial load of the latter. stress becomes I Figure 20 shows two types of construction, w both having the same origin on the trunnion (19) housing. Since the gusset of tangential direc- tion is essentially larger than the one of The elastic stability is checked by assuming chordal direction, its moment arm to the weld that the gusset is a rectangular plate loaded in comprteusstin on et r o p te ded Tis seam is also larger, thereby inducing a larger compression on the two opposite edges.

This load perpendicular to the weld. However, the assumption, although approximate; is con- low stress and deflection affected by the servative. The critical compressive stress is* tangential component may more than compen- K -E (20) sate for the larger load. If both types of con- 1 - struction are feasible, each should be investi- where b = width of loaded edge gated to determine which is preferable. t = thickmess of gusset 50. One method for determining the in- K, = fixity factor determined from fluence of the gusset load involves isolating a the width to length ratio section of the cradle wall and treating it as a E = modulus of elasticity ring.

Its width is assumed equivalent to the v = Poisson's ratio length of the gusset at the weld. This ap- 49. Gussets should be arranged so that the proach is conservative as the analysis does not utilize the stiffness provided by the adjacent transmitted loads will not unduly aggravate cradle wall, thus yielding bending moments the stresses and deflections of the cradle wall. For example, those gussets that are tangent to and deflections somewhat larger than their Forexapl, toseguset tat re anentto true values.

The gussets of the trunnion the cradle generally produce less stress and tu aus h ust ftetuno t d r r e ehousings provide loads equivalent to those on deflection than those that are not tangent. the diagrams shown as Conditions (a)and (b) This characteristic often leads to appreciable th igra sh a tions a) and (b) of Figure 21. The equations that follow are * Reference 7, Page 312, Conditional A, Case 4. specific applications of Case 8 from Reference 7, Reprinted by permission from Formulas for Stress and Strain, 3rd Ed., by R. J. Roark, Copyright 1954, Table VIII, and define the bending moment McGraw-Hill Book Co., Inc. and deflection at critical points on the ring. 19 'I /-