Downloaded from https://www.everyspec.com ) toward the front. One bracket, usually the 52. Pressure is created by the deflection of front, serves merely as a stabilizing structure the cradle wall and the resistance to it provided while the other transmits the recoil rod force by the inner sliding member. When excessive, to the cradle. These forces produce shear and this pressure causes galling of the bearing. bending stresses at the joint between bracket The object is to maintain this pressure within and cradle body. One method for calculating the acceptable limits defined in Paragraph 28.
the stresses and converting these stresses to Equation 39 provides an approximate pressure* applied loads on the cradle body is demon- w strated in the sample problem in Section VI. AD, = -0.467 E-- (39) Local bending moments and deflections are where present at the attachments. These are found I = moment of inertia of ring cross section according to the methods of Paragraph 50 X. = mean radius of ring but, in this case, only two loads are involved.
w = load per linear inch on the periphery Cases 2 and 25 of Reference 7, Table VIII, and Case 25 were used to derive the equations for The bearing pressure induced by the deflec- Conditions ()and (d) of Figure 21 respective- tion can be solved by setting Equation 39 ly. equal to either Equation 33 or 38, whichever is Condition (c): two equal tangential loads appropriate, and solving for w. The bearing symmetrical about the y-axis. pressure becomes M = WR - !sine] (30) = psi (40) - ) LW so 3 where b = length over which the gusset load is MY = WR",R -1)-(T-1 cos sine] applied. (31) V. DESIGN PRACTICE AD. - - sin 0 + 2 Cos 1 (32) A. STRUCTURE F: -'3 I(I 2 + s 53.
The structure should be simple and sym- S- + sin 0 + cos 0] metrical. Simplicity and symmetry offer sev- (33) eral advantages. Fabrication is easier. They Condition (d): two equal and parallel chordal tend to keep weight down. A stronger, more loads symmetrical about the y-axis. compact, and efficient unit is the ultimate result. If a material of large strength-to- M = WR,[1 (0 sin O + cos 0) - weight ratio is needed, high strength is indi- L32 ) cated but if rigidity is also essential, low weight s + ) must be sacrificed and the necessary strength W (8 sin 0 + cos ) derived from a bulkier structure.
Cradles M2 W + 1must be rigid to insure an accurate weapon, sin 6 - 1 coslo (35) therefore the overall design should be directed 7r [(5 ) otoward this end. M2 WR- coso Cos 0 54. The choice of whether forgings, cast- 20) ]ings, or weldments should be used is usually 1 sin 0 (36) determined by the nature of the structure. If 32 high strength-weight ratios are needed, forg- AD = (0 sin 0 + cos 0) ings are used. However, forgings are costly. If weight is not important, castings may be - (sin 2 0 + 1) (37) applicable. They provide large fillets, thus 2- decreasing stress concentrations at re-en- AD, = [ - + - 1 sin0 * Reference 7, Page 142, Case 18.
Reprinted by \ 1permission from Formulas for Stress and Strain, 3rd + + sin 0) cos 0] (38) Ed., by R. J. Roark, Copyright 1954, McGraw-Hill W) 2 Book Co., Inc. (421