US Army Materiel Command AMCP 706-341 — Engineering Design Handbook — Carriages and Mounts Series: Cradles

Downloaded from https://www.everyspec.com )/ From Equation 25 = 24,400 X 8.5 X (-0.346) = -71,700 lb-in From Equation 26 M = WR. r2 (8 sin 0 + cos 8) - sine] LT = 24,400 X 8.5 X 0.419 = 87,000 lb-in From Equation 28 WR.L i AD.- E (6sin0 + cos0) - sin'- - 1 24,400 x 614 0.131. 29 X 106i (0.253) in From Equation 29 (_ ). AD, = E [ (0sin + cos0) + (coso - 2) sinC + 0- 24,400 x 614 0.139. 29 X 1061 (-0.268) = --- n 78. When the gussets are made tangent to the cradle body at the mean radius as shown WR! [40 s in Figure 30b, they tend to develop smaller lT -{ i bending moments and deflections.

The load = 44,900 X 562 Ч 0.127 = 0.1108 1 W increases over the above value by the ratio 29 X 10 6 I - of dlh for the reason presented in Paragraph 71. From Equation 24 W 24,400 = 44,900 lb WD '[(4s h ~E ADAIr7 2 o2)s where d = 6.35 in 44,900 X 562 -0.1062. h = 3.45 in - 29 X 10'I (-0122) = i Other dimensions r A comparison of results obtained for the two types of gussets shows that, although the a = 2 in sin0 = 0.859 tangential type has almost twice the load, the R. = 8.25 in cos 0 = 0.512 bending moments and deflections produced in 0 = 1.033 radian the cradle wall are less than the maximum corresponding values of the parallel gussets. 79.

To compute the induced bearing pres- F e 1 sure, the procedure used in Paragraph 73 is Mz= WR,, .- - sin 0 followed wR,w 44,900 X 8.25 (-0.201) = -74,500 lb-in (-0.467) w--R (-0.122) From Equation 22 0.122 X 44,900 w - 0.467 - 1,422 lb in, peripheral M =WRi2(o9) M( -)From Equation 40, the bearing pressure is = 44,900 x 8.25 X .170 = 63,000 lb-in w 1422 From Equation 23 P6 b- = 9 360 psi 1 33 d , JV