System Utility Function Setting EN 13.4.2 To Select the Source Click on the Source Selection menu tab in the Test menu to select channels CH1 to CH4. 13.4.3 To Start or Stop the Pass/Fail Test Operation Click on the Operation menu tab in the Test menu to start or stop the test operation. After starting the testing operation, the oscilloscope will test the waveform. Select the testing source and set testing rules as needed. Only when the pass test function is enabled can the pass test operation be started or stopped. The testing interface is shown in the following figure: Figure 13.2 Pass/Fail examples 13.4.4 Mask 1.
Create Rules Click on the Mask menu tab in the Test menu to enter the Mask Settings menu, select Create Rule, and enter the Settings menu. Click on the Range menu tab to select the Screen or Cursor. Click on the X Mask menu tab and set the horizontal tolerance range on the pop-up Copyright © Qingdao Hantek Electronic Co., LTD DPO7000 User manual 135