Hantek — DPO7000 UserManual

Decode EN of chip selection lines (CS), clock lines (CLK), and data lines (SDA). The data lines include MISO (master input slave output) and MOSI (master output slave input). The oscilloscope samples channel data on the rising or falling edge of the clock signal (if it is an analog channel, it will also determine whether each data point is a logical "1" or a logical "0" based on the set threshold level). Figure 14.5 SPI Bus Schematic Click [Decode] in the button area to enter the decoding function menu. 1. Bus Type: Click on the Bus Type menu tab and select SPI from the pop-up menu to configure SPI decoding. 2. Bus Status:

Click on the Bus Status menu tab and choose to turn on (ON) or off (OFF) the bus switch function. 3. Mode: Click on the Mode menu tab to select the SPI decoding mode as Timeout or CS. Copyright © Qingdao Hantek Electronic Co., LTD DPO7000 User manual 155