Analyze EN 17.4.7 Range settings Click on the Range menu tab to enter the range setting menu. You can adjust the size and position of the histogram window by setting the left, right, upper, and lower boundaries. Set the boundary value by rotating the knob V0 or the pop-up numeric keyboard. Window size and position can only be set for horizontal or vertical histograms. Note: The adjustment of horizontal time base and vertical gear does not affect the time base size of the histogram range, but only shows synchronous changes with gear. 17.5 Bode Plot Porter plot is a graphical method of describing the frequency response of a system.
The baud chart is the curve that loop analysis can measure the gain and phase of a system as a function of frequency in a switching power supply and operational amplifier feedback network. The gain margin and phase margin of the system can be analyzed through the Bode diagram, and the stability of the system has been determined. The DPO7000 series digital oscilloscope generates a sweep signal within a specified frequency range through a built-in signal generation module, and outputs it to the injection point of the tested switching power supply circuit.
The oscilloscope tests the phase difference change curve and gain change curve of the injection and output ends at different frequencies to draw a Bode plot. You can access the Bode plot by: ⚫ Click on the button area [Analyze] -> Bode Plot to enter the Porter Chart Settings menu. ⚫ Click on the navigation icon [Hantek] in the upper left corner of the screen, select the Porter chart, and enter the settings menu. DPO7000 User manua l Copyright © Qingdao Hantek Electronic Co., LTD 194