Hantek — DPO7000 UserManual

Arbitrary Waveform Generator (Option) EN Click on the Channel menu tab to select channels CH1~CH4. ⚫ Region: Click on the Region menu tab to select the screen or cursor. If the waveform range is selected as the cursor, click on Cursor A and Cursor B , and rotate knob V0 to adjust the positions of the two light markings respectively. Alternatively, click on the Cursor AB and rotate the knob V0 to adjust the positions of both cursors simultaneously. ⚫ Load: Click on the Load menu tab to load the set channel signal. 2. Load waveform: Click on the Load Stored menu tab to enter the Settings menu.

Select the waveform from the internal or external memory in the disk management interface that pops up on the screen, in the format of *. arb. ⚫ Load: Click on the Load menu tab to load the selected channel signal. 3. Creat: Click on the Create menu tab to enter the Settings menu, where users can create any wave according to their needs. ⚫ Frequency: Click on the Frequency menu tab, and you can set the frequency value directly by rotating the knob V0 or on the pop-up numeric keypad. ⚫ Amplitude: Click on the Amplitude menu label, and you can set the amplitude value directly by rotating the knob V0 or on the pop-up numeric keyboard. ⚫ Offset:

Click on the Offset menu label, and you can set the offset value directly by rotating the knob V0 or on the pop-up numeric keyboard. ⚫ Init Points: Click on the Init Points menu tab, and you can set the point by rotating the knob V0 or directly setting the point on the pop-up numeric keyboard. ⚫ Linear Interp: Click the Linear Interp menu tab, and you can choose to turn linear interpolation on or off. ➢ Open: The waveform editor connects two defined points with a straight line. DPO7000 User manua l Copyright © Qingdao Hantek Electronic Co., LTD 224