Arbitrary Waveform Generator (Option) EN ➢ Close: The waveform editor will maintain a constant voltage level between two points and establish a stepped waveform. ⚫ Edit Points: Click on the Edit Points menu tab to enter the point editing settings menu, and define the waveform by assigning a voltage value to it. ➢ PointX: Click on the PointX menu label, and you can set the current point directly by ➢ Coltage: rotating the knob V0 or on the pop-up numeric keyboard. Click on the Coltage menu tab, and you can set the voltage value directly by rotating the knob V0 or on the pop-up numeric keypad. ➢ Insert:
Click on the Insert menu tab to insert a new editable point at the midpoint of the current and next editing points, and the initialization points will automatically increase by 1. If you continue to press Insert , you can add editable points one by one. ➢ Delete: Click the Delete menu tab to delete the current point from the waveform, and the remaining points are connected using interpolation. ➢ Zoom: Click on the Zoom in menu tab to select whether to turn on or off the horizontal time base zoom in function. ➢ Apply: Click on the Apply menu tab to output any currently edited waveform. ⚫ Save any wave: Click on the Save menu tab to enter the Save Settings menu.
Refer to the instructions in the " Store and Load " section. 4. Edit: Click the Edit menu tab to enter the Settings menu, where users can edit the current waveform. ⚫ Frequency: Click on the Frequency menu tab, and you can set the frequency value directly by rotating the knob V0 or on the pop-up numeric keypad. ⚫ Amplitude: Click on the Amplitude menu label, and you can set the amplitude value directly by rotating the knob V0 or on the pop-up numeric keyboard. ⚫ Offset: Copyright © Qingdao Hantek Electronic Co., LTD DPO7000 User manual 225