Hantek — DPO7000 UserManual

Remote Control EN 22 Remote Control The oscilloscope can be remotely controlled in the following three methods: 1. User-defined programming: Users can program and control the oscilloscope through the standard SCPI (Standard Commands for Programmable Instruments) command. For detailed instructions on commands and programming, please refer to the DPO7000 Programming Manual. 2. Using IO software: Users can use IO software to send commands for remote control of the oscilloscope. It is recommended to use the PC software IO provided by Keysight. You can log in to the Keysight official website ( www.keysight.com ) to download the software. Operating steps:

⚫ Establish communication between the oscilloscope and the computer. ⚫ Run IO and search for oscilloscope resources. ⚫ Open the remote command control panel and send commands. This oscilloscope can communicate with a PC through the following interfaces: ⚫ Controlled through USB ⚫ Control through LAN ⚫ Controlled through RS232/485 This chapter will provide a detailed introduction to how to use the IO software provided by Keysight to remotely control the oscilloscope through various interfaces. Note: Before connecting the communication cable, please turn off the instrument to avoid damaging its communication interface. 22.1 Remote Control via USB 1.

Connect the device Connect the oscilloscope (USB VIEW interface) to the PC (USB HOST interface) using a USB data cable. 2. Install USB driver After the oscilloscope is correctly connected to the PC for the first time and turned on, the PC will automatically install the driver, as shown in the Device Manager: DPO7000 User manua l Copyright © Qingdao Hantek Electronic Co., LTD 232