To Set the Vertical System EN 5.1 To Enable or Disable the Analog Channel 1. Enable analog channel For example, after connecting a signal to the CH1 channel, the channel can be opened as follows. ⚫ Click on the channel status label at the bottom of the screen, open the channel, and the label will light up. At the same time, the corresponding button in the button area [CH1] will also light up, and the color will be consistent. ⚫ Press the [CH1] button directly to open the channel, and the light on the corresponding channel knob will also light up. If CH1 is turned on and currently selected, the label is shown in the following figure.
If CH1 is turned on but not currently selected, the label is shown in the following figure. The information displayed in the channel status label is related to the current channel settings (independent of the channel's on/off status). 2. Disable analog channel The simulation channel can be closed through the following methods: ⚫ If the CH1 channel is already open and currently selected, press [CH1] once to close the CH1 channel. ⚫ If the CH1 channel is open but not in the selected state, press [CH1] once to make CH1 in the selected state, and then press the CH1 button again to close the CH1 channel.
⚫ Use the touch screen function to close the channel by clicking on the number on the channel menu at the bottom of the screen. 5.2 To Adjust the Vertical Scale Vertical gear refers to the voltage value represented by each grid in the vertical direction of the display screen, usually expressed as V/div. When adjusting the vertical gear, the waveform display amplitude will increase or decrease, and the gear information in the channel status label will also change in real time. Copyright © Qingdao Hantek Electronic Co., LTD DPO7000 User manual 33