Hantek — DPO7000 UserManual

To Set the Vertical System EN The probe ratio and input impedance of the vertical gear and channel settings are related. By default, the probe ratio is 1X and the input impedance is 1M Ω. The vertical gear range is: 500uV/div~10V/div. When the CH1 channel is open, the vertical gear can be adjusted through the following methods: ⚫ Rotate the knob corresponding to CH1 to adjust the vertical gear within an adjustable range. Rotate clockwise to decrease the gear, and counterclockwise to increase the gear. ⚫ Using the touch screen function, click on the CH1 channel menu at the bottom of the screen, and in the pop-up menu, set the vertical gear.

5.3 To Adjust the Vertical Offset Vertical offset refers to the offset of the zero point position of the channel signal of the waveform in the vertical direction relative to the center of the screen. The unit is consistent with the currently selected amplitude unit. When adjusting the vertical offset, the waveform of the corresponding channel moves up and down, and the offset information in the channel status label also changes in real-time. Adjust vertical offset: ⚫ Using the touch screen function, adjust the vertical offset by dragging gestures. Please refer to the Drag section for specific operations. ⚫ Rotate the offset knob in the button area to adjust the vertical offset.

⚫ Using the touch screen function, click on the CH1 channel menu at the bottom of the screen, and in the pop-up menu, set the offset. DPO7000 User manua l Copyright © Qingdao Hantek Electronic Co., LTD 34