Hantek — DPO7000 UserManual

To Trigger the Oscilloscope EN After setting the triggering conditions, it is necessary to adjust the triggering level to correctly trigger the signal and obtain a stable waveform. Select the Level Select type from the level selection menu tab. ⚫ Level A: Only adjust the upper limit of the trigger level, while keeping the lower limit of the trigger level unchanged. ⚫ Level B: Only adjust the lower limit of the trigger level, while keeping the upper limit of the trigger level unchanged. ⚫ Level AB: Adjust both the upper and lower trigger levels simultaneously, keeping the trigger level difference (i.e. the difference between the upper and lower trigger levels) unchanged. 4. Holdoff:

Please refer to the introduction in the section on Trigger Holdoff for specific settings related to triggering release. 8.6.7 Runt Trigger Under amplitude trigger is used to trigger pulses that cross one trigger level but do not cross another trigger level, as shown in the following figure: Figure 8.8 Runt Trigger ⚫ Forward under amplitude: The pulse spans the low level but not the high level. ⚫ Negative under amplitude: The pulse crosses the high level without crossing the low level. Click on [Trig Menu] in the button area to open the trigger menu. DPO7000 User manua l Copyright © Qingdao Hantek Electronic Co., LTD 72