Hantek — DPO7000 UserManual

To Trigger the Oscilloscope EN ⚫ =[Equal to the set width value]: Only when the negative or positive pulse width is equal to the set width can it be triggered (with a pulse width error of 5%). ⚫ != [Not equal to the set width value]: Only when the negative or positive pulse width is not equal to the set width can it be triggered (with a pulse width error of 5%). 5. Width: Click on the Width menu tab and set the width value directly by rotating the multi-functional knob V0 or the pop-up numeric keyboard. 6. Level Select: After setting the triggering conditions, it is necessary to adjust the triggering level to correctly trigger the signal and obtain a stable waveform.

Select the Level Select type from the level selection menu tab. ⚫ Level A: Only adjust the upper limit of the trigger level, while keeping the lower limit of the trigger level unchanged. ⚫ Level B: Only adjust the lower limit of the trigger level, while keeping the upper limit of the trigger level unchanged. ⚫ Level AB: Adjust both the upper and lower trigger levels simultaneously, keeping the trigger level difference (i.e. the difference between the upper and lower trigger levels) unchanged. 7. Holdoff: Please refer to the introduction in the section on Trigger Holdoff for specific settings related to triggering release.

8.6.8 Superamp Trigger Superamp trigger provides a high trigger level and a low trigger level. The instrument triggers when the input signal passes through the high trigger level or the low trigger level. Click on [Trig Menu] in the button area to open the trigger menu. DPO7000 User manua l Copyright © Qingdao Hantek Electronic Co., LTD 74