Hantek — DPO7000 UserManual

To Trigger the Oscilloscope EN 1. Type: Click on the Type menu label and select "Superamp trigger" to set the over amplitude pulse trigger. After selecting the trigger type, the current trigger setting information (including trigger type, trigger signal source, and trigger level) will be displayed at the top of the screen, which changes with the trigger setting. 2. Source: Click on the Source menu tab and select CH1-CH4. Please refer to the section on triggering data sources for details. Only by selecting the channel that has been connected to the signal as the trigger source can stable triggering be obtained. 3. Polarity:

Select the Polarity of the pulse that can trigger the under amplitude pulse in the polarity menu tab. ⚫ Positive polarity: triggered on a forward under amplitude pulse. ⚫ Negative polarity: triggered on a negative under amplitude pulse. 4. When: Select the trigger limit condition for under amplitude pulse triggering in the When menu tab. ⚫ >[Greater than the set width value]: Only when the negative or positive pulse width is greater than the set width can it be triggered (with a pulse width error of 5%). ⚫ less than the set width can it be triggered (with a pulse width error of 5%). Copyright © Qingdao Hantek Electronic Co., LTD DPO7000 User manual 75