To Trigger the Oscilloscope EN ⚫ =[Equal to the set width value]: Only when the negative or positive pulse width is equal to the set width can it be triggered (with a pulse width error of 5%). ⚫ != [Not equal to the set width value]: Only when the negative or positive pulse width is not equal to the set width can it be triggered (with a pulse width error of 5%). 5. Width: Click on the Width menu tab and set the width value directly by rotating the multi-functional knob V0 or the pop-up numeric keyboard. 6. Level Select: After setting the triggering conditions, it is necessary to adjust the triggering level to correctly trigger the signal and obtain a stable waveform.
Select the Level Select type from the level selection menu tab. ⚫ Level A: Only adjust the upper limit of the trigger level, while keeping the lower limit of the trigger level unchanged. ⚫ Level B: Only adjust the lower limit of the trigger level, while keeping the upper limit of the trigger level unchanged. ⚫ Level AB: Adjust both the upper and lower trigger levels simultaneously, keeping the trigger level difference (i.e. the difference between the upper and lower trigger levels) unchanged. 7. Holdoff: Please refer to the introduction in the section on Trigger Holdoff for specific settings related to triggering release.
8.6.9 Pattern Trigger Pattern triggering requires setting the logical values of each channel and the logical relationships between channels (AND, OR, NOT, etc.). When the logical relationship is met and the set time conditions are met, triggering occurs when the edges of any channel change. The logical values of each channel can be set to: high (higher than the trigger level), low (lower than the trigger level), and none (unrelated). Click on [Trig Menu] in the button area to open the trigger menu. DPO7000 User manua l Copyright © Qingdao Hantek Electronic Co., LTD 76