Administrator Information > Monitoring a Remote Scanner > Receiving Email Notifications When Events Occur Checking a Mail Server Connection You can check the connection to the mail server by performing the connection check. 1. Access Web Config and select the Network tab > Email Server > Connection Test . 2. Select Start . The connection test to the mail server is started. After the test, the check report is displayed. Mail Server Connection Test References 192 Items Settings and Explanation SMTP Server Port Number Enter a number between 1 and 65535. Secure Connection Specify the secure connection method for the email server.
None If you select POP before SMTP in Authentication Method, the connection method is set to None. SSL/TLS This is available when Authentication Method is set to Off or SMTP AUTH. STARTTLS This is available when Authentication Method is set to Off or SMTP AUTH. Certifci ate Validation The certifci ate is validated when this is enabled. We recommend this is set to Enable. POP3 Server Address If you select POP before SMTP as the Authentication Method, enter the POP3 server address between 0 and 255 characters using A-Z a-z 0-9 . - . You can use IPv4 or FQDN format. POP3 Server Port Number If you select POP before SMTP as the Authentication Method, enter a number between 1 and 65535.
Messages Cause Connection test was successful. This message appears when the connection with the server is successful. SMTP server communication error. Check the following. - Network Settings This message appears when ❏ The scanner is not connected to a network ❏ SMTP server is down ❏ Network connection is disconnected while communicating ❏ Received incomplete data POP3 server communication error. Check the following. - Network Settings This message appears when ❏ The scanner is not connected to a network ❏ POP3 server is down ❏ Network connection is disconnected while communicating ❏ Received incomplete data