Delta DVP-ES2 — 3.2 Explanations to Basic Instructions

DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming 3.1 Basic Instructions (without API numbers) Note: The execution speed is obtained by basic test programs, therefore the actual instruction execution time could be longer due to a more complicated program, e.g. program contains multiple interruptions or high speed input/output. 3.2 Explanations to Basic Instructions Explanations: 1. The LD instruction is used to load NO contact which connects to left side bus line or starts a new block of program connecting in series or parallel connection. 2.

DVP-ES2/EX2 series PLCs whose version is 3.20/DVP-SS2 series PLCs whose version is 3.00/DVP-SA2 series PLCs whose version is 2.60/DVP-SE series PLCs whose version is 3-2 Execution speed (us) Instruction Function Operand Steps ES2/EX2/SS2 SE SA2/SX2 LD Load NO contact X, Y, M, S, T, C 0.76 0.64 1~3 LDI Load NC contact X, Y, M, S, T, C 0.78 0.68 1~3 AND Connect NO contact in series X, Y, M, S, T, C 0.54 0.58 1~3 ANI Connect NC contact in series X, Y, M, S, T, C 0.56 0.62 1~3 OR Connect NO contact in parallel X, Y, M, S, T, C 0.54 0.62 1~3 ORI Connect NC contact in parallel X, Y, M, S, T, C 0.56 0.64 1~3 ANB Connect a block in series N/A 0.68 0.68 1 ORB Connect a block in parallel N/A 0.76 0.76 1 MPS Start of branches.

Stores current result of program evaluation N/A 0.74 0.68 1 MRD Reads the stored current result from previous MPS N/A 0.64 0.54 1 MPP End of branches.

Pops (reads and resets) the stored result in previous MPS N/A 0.64 0.54 1 OUT Output coil Y, S, M 0.88 0.68 1~3 SET Latches the ON status Y, S, M 0.76 0.68 1~3 RST Resets contacts, registers or coils Y, M, S, T, C, D, E, F 2.2 1.04 3 MC Master control Start N0~N7 1 0.8 3 MCR Master control Reset N0~N7 1 0.8 3 END Program End N/A 1 0.8 1 NOP No operation N/A 0.4 0.5 1 P Pointer P0~P255 0.4 0.5 1 I Interrupt program pointer I□□□ 0.4 0.5 1 STL Step ladder start instruction S 2.2 2 1 RET Step ladder return instruction N/A 1.6 1.4 1 NP Negative contact to Positive contact N/A 1.66 0.72 1 PN Positive contact to Negative contact N/A 1.62 0.72 1 Mnemonic Operands Function Program steps Controllers LD X, Y, M, S, T, C Load NO contact 1~3 SA2 ES2/EX2 SS2 SX2 SE