Delta DVP-ES2 — 3.2 Explanations to Basic Instructions

3. Instruction Set 1.20/DVP-SX2 series PLCs whose version is 2.40 (and above) support the operands X, Y, M, and S. These operands can be qualified by E or F. Users have to use WPLSoft version 2.31 (or above)/ISPSoft version 2.01 (or above). Program example: Ladder diagram: Instruction: Operation: LD X0 Load NO contact X0 X0 X1 Y1 AND X1 Connect NO contact X1 in series OUT Y1 Drive coil Y1 Ladder diagram: Instruction: Operation: X1 Y1 LD X5E2 Load NO contact X3 (SupposeE2=K-2) AND X1 Connect NO contact X1 in series OUT Y1 Drive coil Y1 Explanations: 1.

The LDI instruction is used to load NC contact which connects to left side bus line or starts a new block of program connecting in series or parallel connection. 2. DVP-ES2/EX2 series PLCs whose version is 3.20/DVP-SS2 series PLCs whose version is 3.00/DVP-SA2 series PLCs whose version is 2.60/DVP-SE series PLCs whose version is 1.20/DVP-SX2 series PLCs whose version is 2.40 (and above) support the operands X, Y, M, and S. These operands can be qualified by E or F. Users have to use WPLSoft version 2.31 (or above)/ISPSoft version 2.01 (or above). Program example: Ladder diagram: Instruction: Operation:

X0 X1 Y1 LDI X0 Load NC contact X0 OUT Y1 Drive coil Y1 AND X1 Connect NO contact X1 in series Ladder diagram: Instruction: Operation: X1 Y1 LDI X7F5 Load NC contact X12 (Suppose F5=K3) AND X1 Connect NO contact X1 in series OUT Y1 Drive coil Y1 3-3 LD X5E2 Mnemonic Operands Function Program steps Controllers LDI X, Y, M, S, T, C Load NC contact 1~3 SA2 ES2/EX2 SS2 SX2 SE X LDI X7F5