Delta DVP-ES2 — 3.2 Explanations to Basic Instructions

3. Instruction Set Ladder diagram: Instruction: Operation: X0 X1 LDI X0 Load NC contact X0 AND X1 Connect NO contact X1 in series OUT Y10F0 Drive Y5 coil (Suppose F0=K-3) Explanations: 1. When the SET instruction is driven, its designated device will be ON and latched whether the SET instruction is still driven. In this case, RST instruction can be applied to turn off the device. 2. DVP-ES2/EX2 series PLCs whose version is 3.20/DVP-SS2 series PLCs whose version is 3.00/DVP-SA2 series PLCs whose version is 2.60/DVP-SE series PLCs whose version is 1.20/DVP-SX2 series PLCs whose version is 2.40 (and above) support the operands Y, M, and S. These operands can be qualified by E or F.

Users have to use WPLSoft version 2.31 (or above)/ISPSoft version 2.01 (or above). Program example: Ladder Diagram: X0 Y0 Instruction: Operation: LD X0 Load NO contact X0 ANI Y0 Connect NC contact Y0 in series SET Y1 Drive Y1 and latch the statu s Ladder Diagram: Instruction: Operation: X0 LD X0 Load NO contact X0 ANI Y0 Connect NC contact Y0 in series SET Y15E5 Drive Y20 and latch the statu s (Suppose E5=K3) Explanations: 1. Device status when RST instruction is driven:

3-9 1 OUT Y10F0 Mnemonic Operands Function Program steps Controllers SA2 ES2/EX2 SS2 SX2 SE Controllers SET Y, M, S Latches the ON status 1~3 SA2 ES2/EX2 SS2 SX2 SE SET Y1 0 Y0 SET Y15E5 Mnemonic Operands Function Program steps Controllers SA2 ES2/EX2 SS2 SX2 SE RST Y, M, S, T, C, D, E, F Resets contacts, registers or coils 3 SA2 ES2/EX2 SS2 SE Device Status S, Y, M Coil and contact are set to OFF. T, C Current value is cleared. Associated contacts or coils are reset . D, E, F The content is set to 0.