Delta DVP-ES2 — Instruction Composition

3. Instruction Set Steps occupied by the 16-bit/32-bit/pulse instruction Applicable PLC models for 16-bit/32-bit/pulse execution instruction. Continuous execution vs. Pulse execution 1. There are two execution types for instructions: continuous execution instruction and pulse instruction. Program scan time is shorter when instructions are not executed. Therefore, using the pulse execution instruction can reduce the scan time of the program. 2. The ‘pulse’ function allows the associated instruction to be activated on the rising edge of the drive contact. The instruction is driven ON for the duration of one program scan. 3.

In addition, while the control input remains ON, the associate instruction will not be executed for the second time. To re-execute the instruction the control input must be turned from OFF to ON again. Pulse execution instruction X0 When X0 goes from OFF to ON, MOVP instruction will be executed once and the instruction will not be executed again in the scan period Continuous execution instruction When X1=ON, the MOV instruction can be X1 re-executed again in every scan of program. This is called continuous execution instruction. Operands 3.

Bit devices X, Y, M, and S can be combined into word device, storing values and data for operations in the form of KnX, KnY, KnM and KnS in an application instruction. 4. Data register D, timer T, counter C and index register E, F are designated by general operands. 5. A data register D consists of 16 bits, i.e. a 32-bit data register consists of 2 consecutive D registers. 6. If an operand of a 32-bit instruction designates D0, 2 consecutive registers D1 and D0 will be occupied. D1 is thehigh word and D0 is the low word. This proncipal also applys to timer T and 16-bit counters C0 ~ C199. 7.

When the 32-bit counters C200 ~ C255 are used as data registers, they can only be designataed by the operands of 32-bit instructions. Operand Data format 8. X, Y, M, and S are defined as bit devices which indicate ON/OFF status. 9. 16-bit (or 32-bit) devices T, C, D, and registers E, F are defined as word devices. 3-17 MOVP D10 D12 MOV D10 D12