3. Instruction Set Operands: D 1 : Device to be exchanged 1 D 2 : Device to be exchanged 2 Explanations: 1. The contents in the devices designated by D 1 and D 2 will exchange 2. It is better to apply a pulse execution for this instruction (XCHP). 3. If operand D1 and D2 use index register F, only 16-bit instruction is available. Program example: When X0=OFF → ON, the contents of D20 and D40 exchange with each other. X0 Before execution After execution 40 D20 120 D20 D40 120 40 D40 Points to note: 1. As a 16-bit instruction, when the devices designated by D 1 and D 2 are the same and M1303 = ON, the upper and lower 8 bits of the designated devices exchange with each other. 2.
As a 32-bit instruction, when the devices designated by D 1 and D 2 are the same and M1303 = ON, the upper and lower 16 bits in the designated device exchange with each other. 3. When X0 = ON and M1303 = ON, 16-bit contents in D100 and those in D101 will exchange with each other. Before execution After execution X0 1234 D100 5678 D100 D101 1234 5678 D101 4. When X0 = ON and M1303 = ON, the high 8 bits and the low 8 bits in D0 are exchanged, the high 8 bits and the low 8 bits in D1 are exchanged., and the high 8 bits and the low 8 bits in D2 are exchanged.
3-69 API Mnemonic Operands Function Controllers SA2 ES2/EX2 SS2 SX2 SE Controllers 17 D XCH P Exchange ES2/EX2 SS2 SA2 SX2 SE Type OP Bit Devices Word devices Program Steps X Y M S K H KnX KnY KnM KnS T C D E F XCH, XCHP: 5 steps DXCH, DXCHP: 9 steps D 1 * * * * * * * * D 2 * * * * * * * * PULSE 16-bit 32-bit SA2 SX2 SS2 SA2 SA2 SX2 ES2/EX2 SS2 ES2/EX2 SX2 ES2/EX2 SS2 SE SE SE XCHP D20 D40 0 M1303 DXCHP D100 D100 DXCHP D100 D100