Delta DVP-ES2 — 3.8 Detailed Instruction Explanation

3. Instruction Set  Table of settings for the high-speed interrupts of the software counters and software comparators:  DVP-SS2/SA2/12SE does not support the software high speed counter C232.  C253 and C254 is DVP/12SE are software high speed counters. The high-speed interrupt  Block diagram of software counters and comparators: is I030. Software comparator x 6 Software Counter 1 Set / reset 1 Software counter 2 Set / reset 2 Count value 6 Set / reset Software counter 8 6. Explanations on hardware comparators DHSCS/DHSCR instruction:

 There are 2 groups of hardware comparators provided respectively for 2 groups of hardware counters (A group and B group), and each group shares 4 comparators with individual Compare Set/Reset function.  When programming DHSCS and DHSCR instructions, the total of Set/Reset comparisons for both instructions can not be more than 4, otherwise syntax check error will occur.  Each high-speed counter interrupt occupies an associated hardware comparator, consequently the interrupt number can not be repeated. Also, I010~I040 can only be  If DCNT instruction enables C243 as high speed counter (group A) and DHSC/DHSC applied for group A comparators and I050~I080 for group B.

instruction uses C245 as high speed counter (group A) at the same time, PLC takes C243 3-127 Counter C232 C233 C234 C235 C236 C237 DHSCS High-speed I010 I050 I070 I010 I020 I030 interrupt High-speed comparator C232~C242 share 6 software comparators Set Counter C238 C239 C240 C241 C242 DHSCS High-speed I040 I050 I060 I070 I080 interrupt High-speed comparator C232~C242 share 6 software comparators Set