Delta DVP-ES2 — 3.8 Detailed Instruction Explanation

DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming 4. Corresponding table between COM ports and communication settings/status. 3-234 Flag Function Action M1319 COM3 data receiving error. M1319 will be set ON when errors occur and the error code will be stored in D1252 System sets, user resets Special register Function D1038 Delay time of data response when PLC is SLAVE in COM2, COM3 RS-485 communication, Range: 0~10,000. (unit: 0.1ms). By using EASY PLC LINK in COM2, D1038 can be set to send next communication data with delay. (unit: one scan cycle) D1109 COM3 (RS-485) communication protocol. Refer to the following table in point 4 for protocol setting.

D1169 The specific end word to be detected for RS instruction to execute an interruption request (I160) on COM3 (RS-485). Supported communication instructions: RS D1252 COM3 (RS-485) Communication time-out setting (ms). If users set up time-out value in D1252 and the data receiving time exceeds the time-out value, M1319 will be set ON and the error code K1 will be stored in D1253. M1319 has to be reset manually when time-out status is cleared. D1253 COM3 (RS-485) communication error code D1255 COM3 (RS-485) PLC communication address when PLC is Slave.

COM1 COM2 COM3 Function Description M1138 M1120 M1136 Retain communication setting Protocol M1139 M1143 M1320 ASCII/RTU mode selection setting D1036 D1120 D1109 Communication protocol D1121 D1121 D1255 PLC communication address - M1161 - 8/16 bit mode selection - M1121 - Indicate transmission status M1312 M1122 M1316 Sending request Sending - M1126 - Set STX/ETX as user/system defined. (RS) RS)RSTX/ETX request - M1130 - Set STX/ETX as user/system defined. (RS) - D1124 - Definition of STX (RS)