3. Instruction Set 144 Operands: S 1 : Width of output pulse S 2 : Pulse output cycle (occupies 3 devices) D : Pulse output device Explanations: 1. When GPWM instruction executes, pulse output will be executes on device specified by D according to pulse output width S 1 and pulse output cycle S 2 . 2. S 1 : pulse output width. Range: t = 0~32,767ms. 3. S 2 : pulse output cycle. Range: T = 1~32,767ms, S 1 ≦ S 2 . 4. S 2 +1 and S 2 +2 are system-defined parameters, please don’t use them. 5. D: pulse output device: Y, M and S. 6. When S 1 0, no pulse output ≦ will be performed. When S 1 ≧ S 2 , the pulse output device remains ON. 7.
S 1 and S 2 can be modified when GPWM instruction is being executed Program Example: Assume D0 = K1000, D2 = K2000. When X0 = ON, Y20 will output pulses as the following diagram. When X0 = OFF, Y20 output will be OFF. X0 t T t=1000ms Output Y20 T=2000ms Points to note: 1. The instruction operates by the scan cycle; therefore the maximum error will be one PLC scan cycle. S 1 , S 2 and ( S 2 - S 1 ) should be bigger than PLC scan cycle, otherwise malfunction will occur during GPWM outputs. 2. Please note that placing this instruction in a subroutine will cause inaccurate GPWM outputs.
3-353 Mnemonic Operands Function Controllers ES2/EX2 SS2 SA2 SX2 SE Controllers GPWM General PWM output ES2/EX2 SS2 SA2 SX2 SE Typ e OP Bit Devices Word devices Program Steps X Y M S K H KnX KnY KnM KnS T C D E F GPWM: 7 steps S 1 * S 2 * D * * * 16-bit 32-bit SA2 SA2 SA2 SS2 SX2 ES2/EX2 SS2 SX2 ES2/EX2 SS2 SX2 SE SE SE GPWM D0 D2 Y20 0