DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming 145 Operands: S 1 : Set value (SV) S 2 : Present value (PV) S 3 : Parameter (sampling time) D : Output value (MV) Explanations: 1. Range of S 1 : 1 ~ 5000 (shown as 0.1 C ~ 500 C). Unit: 0.1 . If ( S 3 +1) is set as K0, the range will be 0.1 C ~ 500 C. 2. Settings of parameter S 3 +1: bit0 = 0 -> C; bit1 = 0 -> F; bit1 = 0 -> no filter function; bit1 = 1 -> with filter function; bit2 ~ bit5 -> 4 kinds of heating environments; bit6 ~ bit15 -> reserved. See remarks for more information. 3. D is the value between 0 ~ sampling time Ч 100.
When using this instruction, the user has to adopt other instructions according to the types of the heater. For example, FTC can be used with GPWM for output pulse control. “Sampling time Ч 100” is the cycle of GPWM pulse output; MV is the width of GPWM pulse. See program example 1. 4. There is no limit on the times of using FTC instruction, but Do not repeatedly use a designated 5. The models which are supported are DVP-ES2/EX2 v. 3.22, DVP-SA2/SX2 v. 2.66, and operand in case an error may occur. DVP-SE v. 1.60 (and above). Program Example: 1. Set up the parameter before executing FTC instruction. 2. When X0 = On, the instruction will be executed and and result will be stored in D150.
When X0 = Off, the instruction will not be executed and the previous data remain unchanged. X0 3-354 Mnemonic Operands Function Controllers ES2/EX2 SS2 SA2 SX2 SE FTC Fuzzy Temperature Control Controllers ES2/EX2 SS2 SA2 SE SX2 Typ e OP Bit Devices Word devices Program Steps X Y M S K H KnX KnY KnM KnS T C D E F FTC: 7 steps S 1 * * * S 2 * * * S 3 * D * PULSE 16-bit 32-bit ES2/EX2 SS2 SA2 SE SX2 SS2 SA2 ES2/EX2 SS2 SA2 SE SX2 ES2/EX2 SX2 SE FTC D0 D1 D100 D150