DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming Program Example 2: When M0 = ON, Y0 pulse output executes zero return with a frequency of 20kHz. When it reaches the DOG switch, X4 = ON and the frequency changes to JOG frequency of 1kHz. When X4 = OFF, it seeks the second X2(Z-phase) pulse input (right-edge trigger signal), and Y4 stops after a pulse (the width of On is 20ms) is output from it (M1029=On). M0 M0 RST M1308 RST M1308 SET M1346 SET M1346 M0 M0 Points to note: 1. Associated Flags: M1029: CH0 (Y0, Y1) pulse output execution completed M1102: Y2/CH1 (Y2, Y3) pulse output execution completed M1106: Zero point selection.
M1106=ON, change the zero point to the right of DOG switch for zero return on CH0 M1107: Zero point selection. M1107=ON, change the zero point to the right of DOG switch for zero return on CH1 M1305: Reverse Y1 pulse output direction in high speed pulse output instructions M1306: Reverse Y3 pulse output direction in high speed pulse output instructions M1307: For ZRN instruction, enable left limit switch M1308: Output specified pulses (D1312) or seek Z phase signal when zero point is achieved. M1346: Output clear signals when ZRN is completed 2. Special D registers: D1312:
Specify the number of additional pulses for additional pulses output and Z-phase seeking function of ZRN instruction (Has to be used with M1308) 3-404 MOV K-2 D1312 DZRN K20000 K1000 X4 Y0